C# code is not getting generated for the given feature file on saving

[ramanaramidi]

Hi,

C# code is not getting generated for the given feature file on saving. The below error message is displayed in the feaure.cs file.

#error Generation error: Could not load file or assembly 'TechTalk.SpecFlow, Version=1.9.0.77, Culture=neutral, PublicKeyToken=0778194805d6db41' or one of its dependencies. The system cannot find the file specified.

I am not sure why the specflow version is displayed as 'TechTalk.SpecFlow, Version=1.9.0.77,

I am currently using the below versions

My Ranorex version is 9.2.1
.Net runtime version 4.0
SpecFlow version 3.1.86


Please help.

Thanks,
Ramana.

[odklizec]

Hi,

Please check this answer...
https://www.ranorex.com/forum/viewtopic ... 432#p55489

Also, Ranorex 9.2.x requires, at very least, .Net 4.6.2! I think this is unrelated to your problem, but anyway, if your .Net version is really 4.0, you should update it with 4.6.2 or higher.

[ramanaramidi]

Hi,

Thanks for the reply. I am using the dotnet framework version 4.6.2 and other things given in the below link are taken care.
https://www.ranorex.com/forum/viewtopic ... 432#p55489

But still I am unable to translate the feature file to C# code.


Regards,
Ramana.

[odklizec]

Hi,

I would suggest to again go though the Ranorex/SpecFlow integration steps and check if everything is set correctly...
https://www.ranorex.com/blog/how-to-use ... d-process/
Check mainly troubleshootings, where you can find paragraph called "The code/csharp file is not generated" Hope this helps?

[ramanaramidi]

Thanks for the help. I have gone through the steps once again and able to generate C sharp file.

[odklizec]

Hi,

Nice to hear that. Have a nice day