Code to execute at the start of every test case

[stapes]

Is there a way I can make a bit of code that will be run at the start of every test case?

I am interested in seeing the Report Level & Error Behaviour of each Test Case.

i.e.

Code: Select all

var ts=TestSuite.Current;  
        	var tc1=(TestCase) TestCase.Current ;
        	Report .Info ("Report Level. Get Level:" + tc1.ReportLevel.ToString ());
            tc1.ReportLevel=Common.GlobalVariables.GlobalLevel; 
            Report .Info ("Set Report Level. Set Level:" + tc1.ReportLevel.ToString ());
            Report .Info ("Error Behavior. Get Error Behavior:" + tc1.ErrorBehavior.ToString ());

[krstcs]

The only way to do it in Ranorex Studio would be to make a new UserCode module and then drop it into the SETUP section of each test case where you needed the info.

[stapes]

I don't see that SETUP does anything but stick a label on your test report.
I already have this class at the start of every Test Case. I was just wondering if there was an override method I could use to do this.

[krstcs]

No, there's no override method for the test cases. If you want to make a feature request, you can send it to [email protected].


The SETUP and TEARDOWN sections are run regardless of current test status (Success, Failed, etc.). They do label and segregate the test modules inside them so the test cases are a bit easier to read, but the real benefit of them is that they run no matter what the status is.

[stapes]

Ah. That is helpful. Thanks.