Data file or transformation not found.
- taoyang987
- Posts: 19
- Joined: Sun Jan 06, 2013 8:43 am
Data file or transformation not found.
after the report is created,it shows the message"Data file (XXXXX.rxlog.data) or transformation not found."so i updated ranorex from 4.1.0 to 4.1.1,but the problem remains。 i copy the report files to an other computer,the report shows well.
- Support Team
- Site Admin
- Posts: 12145
- Joined: Fri Jul 07, 2006 4:30 pm
- Location: Houston, Texas, USA
- Contact:
Re: Data file or transformation not found.
Hi,
I assume you started your tests in Ranorex Studio and after the test finished the report poped up stating that the *.rxlog.data file cannot be found, is this right?
May I ask you to answer the following questions?
Did you manually stop the execution?
Was the test run successful?
Do you have the same problems when you open older reports with Studio?
Can you open the specific report with the report viewer?
Does this just happen with specific reports or with all of the generated ones?
Thanks,
Markus
I assume you started your tests in Ranorex Studio and after the test finished the report poped up stating that the *.rxlog.data file cannot be found, is this right?
May I ask you to answer the following questions?
Did you manually stop the execution?
Was the test run successful?
Do you have the same problems when you open older reports with Studio?
Can you open the specific report with the report viewer?
Does this just happen with specific reports or with all of the generated ones?
Thanks,
Markus
- taoyang987
- Posts: 19
- Joined: Sun Jan 06, 2013 8:43 am
Re: Data file or transformation not found.
thank you for your advice.i'll try it.