Generate report only if testcase fails

Ranorex Spy, Recorder, and Studio.
swrobleski
Posts: 1
Joined: Wed Feb 20, 2013 11:26 pm

Generate report only if testcase fails

Post by swrobleski » Wed May 29, 2013 6:38 pm

Hello,
Is there a way to only generate a report if there is a failure?
I'm running a group of test cases continuously. Every so often I will review all of the reports to see if there are any failures. I have the report level set to failure, so the detail is only there on failures. I would prefer there was no report generated unless there is a test case failure. This would make the process of reviewing the reports much more efficient.

Thanks,

Scott

User avatar
Support Team
Site Admin
Site Admin
Posts: 11709
Joined: Fri Jul 07, 2006 4:30 pm
Location: Graz, Austria

Re: Generate report only if testcase fails

Post by Support Team » Fri May 31, 2013 2:23 pm

Hello Scott,

Unfortunately there is no such a setting at the moment, but I will treat this as a feature request.
We will discuss internally if we can provide such a setting in one of our future releases.

Regards,
Bernhard
.
Image