Image not found in element error on first pass, but succeeds when starting from failed step

Ranorex Spy, Recorder, and Studio.
dhudson
Posts: 1
Joined: Wed Dec 20, 2017 12:43 am

Image not found in element error on first pass, but succeeds when starting from failed step

Post by dhudson » Thu Nov 01, 2018 10:47 pm

So, I have been troubleshooting this for a couple of days now and not making any head room. I have a Module where I am trying to locate an item in a control by image. The module runs to this step, then fails to locate the image. However, if I immediately then highlight the same step that failed, and have it 'Run from here', it will complete the module, including this step, without any issue. I cannot seem to come up with any way to work around this.

Has anyone run into a case like this and have any ideas on how to work around it?
Thanks.

qwertzu
Posts: 178
Joined: Wed Jan 25, 2017 11:08 am

Re: Image not found in element error on first pass, but succeeds when starting from failed step

Post by qwertzu » Mon Nov 05, 2018 3:19 pm

hi dhudson,

have you already tried to add a delay action before this specific step?
If this does not help, please upload a ranorex snapshot of your element and a compressed report of your failed test run.

regards, qwertzu