Hi I have quite few Setup and Teardown tests within my test suite which will run some common functions like login, logout etc.
I have also used few Soft failure reports based on comdition
like report.failure(message,message)
Problem: After upgrading to 5.3, test will fail and comes out of loop when it detects soft failures:(
It never executes any tests below set up or ones after. I tried all combinations of Error behaviour options and its same.
If I remove soft failures it works fine
Quick feedback much appriciated
Ranorex 5.3 problem
- Support Team
- Site Admin
- Posts: 12145
- Joined: Fri Jul 07, 2006 4:30 pm
- Location: Houston, Texas, USA
- Contact:
Re: Ranorex 5.3 problem
Hello cruzez,
Report.Failure() is no “soft failure”. Please try to use Report.Error() instead.
Hope this helps.
Regards,
Robert
Report.Failure() is no “soft failure”. Please try to use Report.Error() instead.
Hope this helps.
Regards,
Robert