Ranorex 9.0: After execution, Ranorex report is not poping up on the main screen automatically.

[chiranthurs]

Hi Team,

In Ranorex 9.0 after executing the testsuite, the ranorex report is not popping up on the screen. My collegues who were working on Ranorex 5.3.2 are not happy with it as it used to pop up immediately after the execution. Is there any setting that has to be done to enable it?

Regards,
Chiranth

[odklizec]

Hi,

If this problem appeared after converting an old 5.x solution to 9.x format, then I guess it's most probably caused by the conversion? Ranorex 5.x is really too old and there may be an unexpected problem, caused by solution conversion to recent version?

Anyway, have you tried to run a new project, created with Ranorex 9.0? At next, please check your actual setting in Tools >> Options >> General >> Ranorex Report viewer:

Open_report_after_execution.png

If it's already checked, try to uncheck it, confirm the dialog and then try to enable it again. Hope this helps?

[chiranthurs]

Hi Odklizec,

We tried the resolution but it did not work.

Regards,
Chiranth

[odklizec]

Hi,

Does it happen also with fresh new solution, created in Ranorex 9.0? If yes, then it's most probably not caused by old porject conversion. In this case, I would suggest to completely uninstall Ranorex and install it back. And if this does not help either, then contact Ranorex support via support form available here:
https://www.ranorex.com/support-query/