Ranorex calls an external library

[OPT-Liuxm]

Hello everyone.

I still have a problem that I haven't solved.

I use Ranorex to call outside libraries, and then I call the library's methods,As shown in figure 1.

When I started Ranorex Studio to run the tests, the tests, after executing the user code, could not execute the recorded results, and I don't know why. As shown in figure 2.

[odklizec]

Hi,

Could you please post the content of GetMessage? Have you tried to debug the code? Are you sure the library is compiled with the same version of Ranorex?

[OPT-Liuxm]

Thanks for your reply.

what you said is....NET version?
Is the.net version of Ranorex available at help-> About?

I added the library file through the.net Assembly Browser,as shown in the figure.

Best wishes for you.

[OPT-Liuxm]

Oh, I forgot to mention that my library is compiled by VS, not Ranorex.

[odklizec]

Hi,

OK, I though the library you are using is Ranorex-based lib, and this is why I asked if it was compiled with the same version of Ranorex. Anyway, have you tried to compile the library in debug mode and then tried to debug the whole test? Just set a breakpoint at GetMessage step, run the test and go into the library by F11 (step into) key. Hope this helps? My guess is, that it fails somewhere in the library?

[OPT-Liuxm]

Yes, when I make a consistent version of.NET and test it in debug mode, it can be executed.
Thank you very much.

[odklizec]

Hi,

Nice to hear that!