Ranorex doesn't show details of test report

[exelents]

Hello.
I have done a demonstration test, but when i run it through run button on instrumental panel, which starts the whole project, at the end Ranorex Studio doesn't show me in a log report a full detalization step-by step. It only shows a result code (success/failed) and launched test case, but no information about steps executed or error stack. See screenshot:
https://drive.google.com/file/d/0B_vtGd ... sp=sharing

But, if I try to execute a few actions through recording tab (Run from here / Run selected items) I can see all actions in log report.
Report level on my tests I have set on "Info".

What can I do to turn on actions log in my report?

[odklizec]

Hi,

This problem is most probably caused by IE settings. Please check this post...
https://www.ranorex.com/forum/ranorex-r ... tml#p47936

[Support Team]

Hi exelents,

This is odd... I assume it is running the modules since this was an 11-minute test and a test case would not run unless it had at least one module within it. If odklizec's recommendation does not help, are you able to provide a compressed copy of this Ranorex Report file (compressed) so I may further analyze it? Providing the entire solution (compressed) may also prove to be beneficial in finding the root cause of this issue.

Looking forward to your reply!

Regards,
Ned

[exelents]

Hi,

This problem is most probably caused by IE settings. Please check this post...
https://www.ranorex.com/forum/ranorex-r ... tml#p47936

Thank you! It helped!