Hi,
I'm new to Ranorex tool, i just started with recording few scenarios on my flex application.
The problem i found is, i was unable to identify some flex objects in my application.
Is there any setting or setup that i need to do before i start with flex application automation? because it is not identifying only some objects.
Thanks,
Teja
Some flex objects are not recognised by Ranorex spy
- Support Team
- Site Admin
- Posts: 12145
- Joined: Fri Jul 07, 2006 4:30 pm
- Location: Houston, Texas, USA
- Contact:
Re: Some flex objects are not recognised by Ranorex spy
Hello teja,
Welcome to Ranorex.
In order to test your Flex application you need to properly instrument your application. Further information about Flash/Flex Testing can be found within our UserGuide.
Hope this information helps.
Regards,
Robert
Welcome to Ranorex.
In order to test your Flex application you need to properly instrument your application. Further information about Flash/Flex Testing can be found within our UserGuide.
Hope this information helps.
Regards,
Robert