our company uses TestRail 5.5 and Ranorex 8 for automation. I already used the integration wizard and getting results from Ranorex to a dedicated test run in TestRail. So far so good.
I would like to know if there are ways to link steps from a TestRail test case to its counterpart in Ranorex.
I created a test case in TestRail with 5 steps,
imported the case to Ranorex and built the test case.
But in the end I can only send 1 result to Testrail:
Success. Everything went smoothly. Green result and some generic information about the test case
Failed: Details from Ranorex what module/ action failed, but not exactly what step failed
But I would like to have the following behavior for a failed test case:
Failed: Details from Ranorex about steps that worked and the step that caused the failure.
Is there a way to do this?
Thanks for your reply.
Ask general questions here.
1 post • Page 1 of 1