I am running version 3.2.1.15734, .NET Runtime Version 4.0.30319.225, Windows XP.
While going though your Lessons I noticed that instead of your 'Currently used variables by the recording' picture I was getting only Gender and Category names even Ranorex Module Browser showed all of them within AddVip folder.
Thank you, Valery
User Guide Lesson 3 - Variables list is incomplete
- Support Team
- Site Admin
- Posts: 12167
- Joined: Fri Jul 07, 2006 4:30 pm
- Location: Graz, Austria
Re: User Guide Lesson 3 - Variables list is incomplete
Hi,
I opened the AddVIP recording from the VIPTestSuite and in my case all the variables which are mentioned in the lesson are normally displayed.
Regards,
Markus
Ranorex Support Team
I opened the AddVIP recording from the VIPTestSuite and in my case all the variables which are mentioned in the lesson are normally displayed.
Do you clicked on the "VARIABLES..." in the specific recording or what do you mean with "I was getting ..."?I was getting only Gender and Category names
Regards,
Markus
Ranorex Support Team
Re: User Guide Lesson 3 - Variables list is incomplete
I did not mention my actions because I followed your instructions in the Lesson - the last picture in "Using Variables within the Repository", - and only two variables were listed instead of four ...
- Support Team
- Site Admin
- Posts: 12167
- Joined: Fri Jul 07, 2006 4:30 pm
- Location: Graz, Austria
Re: User Guide Lesson 3 - Variables list is incomplete
Hi,
I think you've opened the repositories variables dialog instead of the recordings variables dialog.
Please have a look at following attached screen shot and make sure to open the right dialog.
Regards,
Tobias
Ranorex Support Team
I think you've opened the repositories variables dialog instead of the recordings variables dialog.
Please have a look at following attached screen shot and make sure to open the right dialog.
Regards,
Tobias
Ranorex Support Team
- Attachments
-
- different variables dialogs
- Variables.png (107.09 KiB) Viewed 1265 times