Ranorex Forum

Hello together,

we use the KendoUi and I would still record some buttons in tables, which are only showed, when the mouse is over defined location area in table.

I tried with mouse => move, but I can not insert the exact location (X,Y) of the target area. And If I use mouse click Ranorex didn't find the buttons, because they are hided.

Normally I go with mouse over this area => the buttons are showed, I go with the mouse an the same line on the button is shown and than a click on this buttons. Ranorex don't go to the buttons on same line. So the buttons are hided again.

Screenshot attached.

Has someone an idea?

Thanks a lot in Advance.

Hi,

Please post a Ranorex snapshot of the problematic element. Screenshot is not useful at all. Ideally, post two snapshots...one with enabled button and the other one with hidden button. Use Instant Tracking to track the dynamic elements. Thanks.