Page 1 of 1

Missing data bindings after saving and reopening solution

Posted: Fri Nov 13, 2015 11:24 am
by nico
Yesterday I saved my solution and when I reopened the solution today, I am missing all my data bindings.
I have all the variables, I have all my parameters. But none of them are binded anymore.

Very annoying since it are over 300 variables that need to be re-binded.

Working with Ranorex 5.4.1.25490
.NET 4.0.30319.1026
On Windows Server 2008

Re: Missing data bindings after saving and reopening solution

Posted: Fri Nov 13, 2015 2:24 pm
by odklizec
This should definitely not happen. Unfortunately, it's hard to tell what caused it. I would suggest to send corrupted solution to Ranorex support. Maybe they can find what's wrong and eventually fix your solution?

Anyway, you should be able to restore last good state from version control system? I hope you are using one? Because if not, you should start right away! Version control system is an important part of any development, including test automation development.