Page 1 of 1

How to make the ranorex config file auto open before each ex

Posted: Sat Sep 19, 2015 3:47 pm
by Polly123
We have a need for entering device information, version numbers etc in the config file. This information is different for each execution/test case. All the info from the config file is later populated into a formal report.

Often, due to manual errors, the entered information is incorrect/incomplete. Due to this we end up re-running the tests after rectifying the info in the config file.

Is there any way to make the config file auto-open when the executor hits the green 'Run' button so that he would be reminded to check his set-up details for that execution? The execution should resume after he closes the config.

Re: How to make the ranorex config file auto open before each ex

Posted: Mon Sep 21, 2015 3:05 pm
by Support Team
Hi Polly123,

Unfortunately, this intention is currently not possible.

In order to raise a feature request I may ask you to send an email to [email protected]?

We would like to handle feature requests via email in order to avoid misunderstandings.

Thank you in advance.

Regards,
Markus (S)