Ranorex Forum

With Ranorex 6.0 I instrumented and deployed my application on a android phone, after deploying there are some settings to be done on the application , which I have done them latter

What ever for a while later I tried to record my application but hen I start recording it shows device as connected but there is no application (same phone, same pc and same renorex same recording module)
seen, so do I need to deploy again for every new recording ?

Resume Recording popup says "Only fully connected devices with a running app will show up" and my device is connected and the application is up and running, but couldnt see my application.

Hi,

If you are using 6.0, I would strongly recommend to use at least 6.0.1, because 6.0 contained some critical bugs. I'm not sure if any of them can be a cause of your issue, but it's worth a try never version? Honestly, I would go straight to 6.1.1, even if it would mean using it in Trial mode (in case you don't have valid license).

As for your recent problems with mobile apps, I think you will have to contact directly Ranorex support (at [email protected]) and provide them with your APK. As I see it, your problems appear to be either application or instrumentation specific and there is not much people here can do for you. At least I don't remember reading about any of your recent mobile-related problems.

odklizec I tried 6.1 after our license issue was solved but could deply it with 6.1 thats why I ried with 6.0, will try 6.1 again soon, thanks.