Page 1 of 1
Ranorex cannot find qt elements when autotest is run
Posted: Wed Jun 05, 2019 8:33 am
by kosto
Good day! I have a programm on QT when is used Qt WebKit. If i run a programm myself, RanorexSpy finds all necessary WebElements. If i would ran Ranorex test, Ranorex couldn t found no one element. Do you have any ideas on this problem? Thanks
Re: Ranorex cannot find qt elements when autotest is run
Posted: Wed Jun 05, 2019 1:21 pm
by odklizec
Hi,
Without seeing your app under test, and (at very least) a Ranorex snapshot, taken both via Studio Spy and standalone Spy, there is not much anyone here can do or suggest. Also, are you using most recent 9.1?
My best guess is, that your Studio settings are different, than standalone Spy settings (they are independent). So I would suggest you to export standalone Spy settings and import them in Studio settings.
Re: Ranorex cannot find qt elements when autotest is run
Posted: Fri Jun 07, 2019 10:24 am
by kosto
The Studio Spy and standalone Spy have same results when i use scenario, written later.
This is snapshot where elements are seen. The other one which is not working is the same as the 1st snapshot, but after "Dom" will not nothing shown.
Test runs a programm, logs in and then test. If i ran a proogramm once by myself and loged in, Web elements would be founded.
If i loged out after this and ran Ranorex test(begining on log in), the elements would still be shown.
But if i ran test in the beginning of all (including run the programm), no one Web element be shown.
Re: Ranorex cannot find qt elements when autotest is run
Posted: Fri Jun 07, 2019 12:42 pm
by odklizec
Hi,
According to the snapshots, you are using Ranorex 9.0.0? Since this version was known to be affected by some pesky bugs, I would strongly recommend to update to more recent 9.0.1 or even better, 9.1.0. Both these versions fixed a lot of bugs. It really makes no sense to debug your issue with an obsolete version, while the problem may already been fixed?