Page 1 of 1

Validation - no message -

Posted: Fri Aug 20, 2010 12:23 pm
by SanMan
Hi,

sorry if question been asked before :oops:

Is there some way to make "Validate.Attribute..." so, that there would be no message to Ranorex Test Report?

Re: Validation - no message -

Posted: Fri Aug 20, 2010 3:11 pm
by Support Team
Using the Validate.EnableReport property (see Ranorex API documentation) you can set whether validation messages should be included in the report.

Regards,
Alex
Ranorex Team

Re: Validation - no message -

Posted: Tue Aug 31, 2010 6:53 am
by SanMan
Thanks a lot again. :)