Page 1 of 1

Report....

Posted: Thu Aug 25, 2011 9:08 am
by Todor
Dear Ranorex Support Team and other Members of this forum,

I have a question concerning the Ranorex Report. I have a Code Module, that browses through all the sites and reports wether there is a 404 error or not. The problem is that when one Iteration of the 16 I currently have fails, all other Iterations are Ignored and i get a report where even the upper folders are failed. My question is: Is it possible to continue on fail but if (for example) one iteration fails that the upper folders are not effected by that? I mean that the folders above the folder with the iteration are not red in the report.

If i have a folder order like this:

Code: Select all

Search
          Setup
          SearchNow
                         Iteration1
                         Iteration2  --> If this one fails the report should 
                                               say that there were 6x Success 
                                               and 1x Fail 
                         Iteration3
          Teardown



Thank you in advance

Re: Report....

Posted: Thu Aug 25, 2011 9:30 am
by Support Team
Hi,
Todor wrote:Is it possible to continue on fail but if (for example) one iteration fails that the upper folders are not effected by that? I mean that the folders above the folder with the iteration are not red in the report.
With 3.1 it will be possible to set the Report Level for the Continue on Fail action. Then you have the free choice which state should be logged if your action fails or succeeds.

Regards,
Peter
Ranorex Team

Re: Report....

Posted: Thu Aug 25, 2011 9:33 am
by Todor
When will Version 3.1 be released? :)

Re: Report....

Posted: Thu Aug 25, 2011 9:38 am
by Support Team
Todor wrote:When will Version 3.1 be released? :)
End of August Ranorex 3.1 will be available.

Regards,
Peter
Ranorex Team