Page 1 of 1

Ranorex - QC Integration Issue

Posted: Mon Aug 13, 2012 11:45 am
by Anbu
Hi Team,

We are trying to integrate Ranorex with QC by follwing the steps mentioned in Ranorex Blog. We were able to create the VAPI-XP Test in Test Plan in QC. However, we couldn't find the 'Parameters' tab in Test Plan. It is available only for MANUAL Test type. Please let us know if we need to configure something in QC to get the Parameters tab. Our QC version is 10.

Thank you,
Anbu K

Re: Ranorex - QC Integration Issue

Posted: Tue Aug 14, 2012 1:32 pm
by Support Team
Hi Anbu,

We used the QC version AMO 11 for our blog. I am afraid that the 'Parameters' tab is new in this version.

Regards,
Bernhard
Ranorex Support Team

Re: Ranorex - QC Integration Issue

Posted: Mon Aug 20, 2012 11:37 am
by Anbu
Hi Bernhard,

Thank you for your response. I have a clarification on AMO as I couldn't find it anywhere. Please could you let me know what AMO stands for? Is it a add-in for QC or upgraded version of QC?

Thank you,
Anbu K

Re: Ranorex - QC Integration Issue

Posted: Tue Aug 21, 2012 8:42 am
by Support Team
Hello,

Sorry that was a typing error!
I meant the ALM edition of QC (Application Lifecycle Management).

Regards,
Bernhard
Ranorex Support Team