Page 1 of 1

how to validate rows

Posted: Fri Nov 21, 2014 3:36 pm
by strannik
Hi All,

The system creates two rows instead of one. Is it possible to validate rows on GUI that only one should exist.

Thank you.

Please see an attachment

Re: how to validate rows

Posted: Mon Nov 24, 2014 4:36 pm
by Support Team
Hi strannik,

You could for instance use one of the find methods in combination with a general RxPath which would identify all rows of your table to find out how many rows are shown.
But in order to answer this question in more detail I would need a Ranorex snapshot of your table could you therefore send (to [email protected]) or upload a Ranorex snapshot of your table when more rows are shown?
The following link will show you how to generate a snapshot file: Creating Ranorex Snapshot Files.

Thanks,
Markus

Re: how to validate rows

Posted: Mon Nov 24, 2014 10:01 pm
by strannik
Hi Markus,

Here is a snapshot. Please take a look.

Thank you.

Re: how to validate rows

Posted: Tue Nov 25, 2014 9:28 am
by odklizec
Hi, the posted snapshot is a snapshot of Ranorex web page ;) Please take the snapshot of table in question.