Page 1 of 1
"Waiting for (0)ms" remains for more than 30 secs.
Posted: Mon May 30, 2016 1:00 pm
by tejas.deshpande
While execution "Waiting for (0)ms" is displayed and it stays for a long time. It is the module duration for user codes. On changing the value to 100ms the execution is relatively faster but still takes a couple of seconds to continue.
Re: "Waiting for (0)ms" remains for more than 30 secs.
Posted: Mon May 30, 2016 1:15 pm
by odklizec
Hi,
Without more details (and project sample), it's almost impossible to tell what's the cause of your issue and suggest reliable solution.
Firstly, what version of Ranorex do you use?
Could you please post a sample test suite, showing your issue?
Have you tried to run the solution without attached debugger (Ranorex6.0) or release version (Ranorex 5.x)?
Have you tried to debug your code, to analyze the source of slowdown? Where exactly in your code it slows-down?
BTW, please remember that the test automation is mainly about consistency, not about speed! You may enable Turbo mode for recording modules, decrease mouse action time, replace mouse clicks with PerformClick actions, so your tests may run noticeably faster. However, due to these changes, your tests may also start to fail due to unexpected/unhandled states or missing mouse events.