Ranorex Forum

Hello.
I have done a demonstration test, but when i run it through run button on instrumental panel, which starts the whole project, at the end Ranorex Studio doesn't show me in a log report a full detalization step-by step. It only shows a result code (success/failed) and launched test case, but no information about steps executed or error stack. See screenshot:
https://drive.google.com/file/d/0B_vtGd ... sp=sharing

But, if I try to execute a few actions through recording tab (Run from here / Run selected items) I can see all actions in log report.
Report level on my tests I have set on "Info".

What can I do to turn on actions log in my report?

Hi,

This problem is most probably caused by IE settings. Please check this post...
https://www.ranorex.com/forum/ranorex-r ... tml#p47936

Hi exelents,

This is odd... I assume it is running the modules since this was an 11-minute test and a test case would not run unless it had at least one module within it. If odklizec's recommendation does not help, are you able to provide a compressed copy of this Ranorex Report file (compressed) so I may further analyze it? Providing the entire solution (compressed) may also prove to be beneficial in finding the root cause of this issue.

Looking forward to your reply!

Regards,
Ned

odklizec wrote: ↑

Mon Jun 10, 2019 5:07 pm

Hi,

This problem is most probably caused by IE settings. Please check this post...
https://www.ranorex.com/forum/ranorex-r ... tml#p47936

Thank you! It helped!