Maintenance mode | Ranorex
HomeUser GuideMaintenance mode

Maintenance mode

Maintenance mode allows you to catch and resolve certain errors during test execution. You can then apply the fixes to your test suite from the report. This saves time because you don’t have to let the entire test run through to start diagnosing and fixing errors.

In this chapter

    Activating maintenance mode

    First, make sure Debug is enabled under Build > Set configuration. The option is usually enabled by default. It is not the same as the debug mode you enable from the menu bar.

    Activate maintenance mode using the switch in the test suite view. Now when you run your test, it will be executed in maintenance mode. When you close the test suite view and reopen it, maintenance mode will be turned off again.

    Note icon

    Note

    Do not change the name of the folder or the file. If you remove the settings file (“Ranorex.rxsettings”), the solution settings stored on the local machine are automatically used during test execution. If you open the settings file, it is shown in its raw format. It is not recommended to edit the file in this view.

    Catching and resolving errors

    When maintenance mode is active, it catches Ranorex-native errors and pauses test execution upon doing so. Depending on the error type, different dialogs with different options will appear.

    Some options are always available:

    Open report Opens the report.
    Continue with error

    Continues test execution according to the error behavior set for the test container.

    Abort test run

    Aborts the test run.

    Element not found

    This dialog is displayed when a repository element couldn’t be found. It displays the related error message and the RanoreXPath of the element.

    Click Edit and retry to open Ranorex Spy. You can then retrack the element or change its path manually. Once you apply the changes in Spy, Ranorex Studio will automatically try to run the failed action again with the updated path.

    You can also click Retry to try again without changing anything. This is useful if you think the path is correct and the element couldn’t be found because the search timeout was too short or the SUT hadn’t reached the correct state yet.

    Validation failed

    This dialog is displayed when a value couldn’t be validated. It displays the validation error message with the expected and actual values.

    The drop-down menu contains the expected value (first option) and the actual value (second option). Select the actual value and then click Apply and retry to run the failed action again with this value.

    Note icon

    Note

    Image validations cannot be resolved in maintenance mode. The generic dialog will be displayed for them.

    Generic dialog

    This dialog appears for all Ranorex-native errors that are currently not resolvable in maintenance mode. Click Open Spy to inspect the affected element in Ranorex Spy. This can help you diagnose why the error occurred.

    Applying your fixes

    Once you’ve resolved the errors that appeared in maintenance mode and your test has executed successfully, you can apply the fixes to your test suite in the report.

    In the report, maintenance mode events are indicated by a special icon:

    Expand the report item to receive more information. Find the maintenance mode event with the green check mark and hover over it to apply the fix to the test suite:

    Note icon

    Note

    Fixes for variables and data bindings cannot be applied automatically. You will need to manually fix these. This applies to both validation values and RanoreXPaths.